The Power Lift system is used to raise and lower the mill head with the flip of a switch.
- The Power Lift is controlled by the motor control toggle switch which has two momentary positions: up and down.
- The 12VDC reversible gear motor has an intermittent duty cycle and has been tailored to the specific requirements of the Power Lift.
Using the Power Lift system is really easy. Just press the switch up or down and release, and you are done. It is much faster than using the hand wheel, and much easier on your shoulder.
- 12VDC Gear motor
- Motor plate
- Motor switch assembly
- Switch bracket & enclosure
- 12VDC power supply
- Power Cord
- Motor coupling
- Parts bag
Important! The Power Lift installed on the Priest Tools PM-728V-T functions properly without the assistance of a gas spring. However, a separate test site using the Power Lift required the purchase and installation of a gas spring kit to assist in lifting the headstock. If the purchase of a gas spring is required, McMaster part 9416K22 is recommended. McMaster offers an assortment of mounting hardware, or custom mounting brackets could be made.Brochure Installation Guide